Publicité
Les langues disponibles
Les langues disponibles
Operating modes
This appliance can be used in exhaust-air mode or circulating-
air mode.
Exhaust air mode
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior by a
pipe system.
Note: The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heating appliances.
Before conveying the exhaust air into a non-functioning
■
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
Operation
These instructions apply to several appliance models.
It is possible that individual features are described which
do not apply to your appliance.
Note: Switch on the extractor hood when you start cooking
and switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel variant 1
2Q2II
IDQ VHWWLQJV
5HGXFH IDQ VSHHG
Control panel variant 2
/LJKW 2Q2II
'LVSOD\
/LJKW 2Q2II
,QFUHDVH IDQ VSHHG
,QWHQVLYH VHWWLQJ
)DQ VHWWLQJV
If the exhaust air is conveyed through the outer wall, a
■
telescopic wall box should be used.
Circulating-air mode
The air which is drawn in is cleaned
by the grease filters and an activated carbon filter
and conveyed back into the kitchen.
Note: To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options of operating
the appliance in circulating-air mode can be found
in the brochure or ask your dealer. The required accessories
are available from specialist outlets, from customer service
or from the Online Shop. The accessory numbers can be found
at the end of the instructions for use.
Switching on fan: variant 1
Press On/Off button.
Increase fan setting by pressing button
it by pressing button
A
.
Intensive setting
You can use the Intensive setting for particularly strong odour
and fume generation.
Keep pressing button
@
until
Run time is limited. Then the appliance sets automatically a
lower fan setting. You can always switch back manually.
Fan run-on
Keep pressing button
until
A
run time is limited. The appliance runs for 10 minutes at fan
setting 1 and then switches off by itself.
Switching on fan: variant 2
Increase or reduce the fan settings by pressing
buttons 1, 2 and 3.
Light
The light can be switched on and off independently of the fan.
@
or reduce
˜
/
›
is indicated on the display.
is indicated on the display. The
–
13
Publicité
