HomeMatic IP HmIP-RGBW Notice D'installation Et D'emploi page 34

Troubleshooting
6 Troubleshooting
6.1 Error codes and flashing sequences
Flashing code
Short orange flash-
es
1x long green flash
Short orange flash-
es (every 10 s)
6x long red flashes
1x orange and 1x
green flash
1x long red flash
6.2 Command not confirmed
If at least one receiver does not confirm a command, the device LED
(A) lights up red at the end of the failed transmission process. The failed
transmission may be caused by radio interference (see "9 General infor-
mation about radio operation" auf Seite 36). This may be caused by
the following:
• Receiver cannot be reached.
• Receiver is unable to execute the command (load failure, me-
chanical blockade, etc.).
• Receiver is faulty.
34
Meaning
Radio transmission/
attempting to trans-
mit/data transmis-
sion
Transmission con-
firmed
Pairing mode active Enter the last four numbers
Device defective
Test display
Transmission failed
or duty cycle limit
reached
Solution
Wait until the transmission
is completed.
You can continue opera-
tion.
of the device's serial
number to confirm (see "5.3
Pairing" auf Seite 31).
Please see your app for
error message or contact
your retailer.
You can continue once the
test display has stopped.
Please try again (see sec.
"6.2 Command not con-
firmed" auf Seite 34 or
"6.3 Duty cycle" auf Seite
35).