HomeMatic IP HmIP-RGBW Notice D'installation Et D'emploi page 31

Proceed as follows to mount the LED controller in a partition wall or false
ceiling:
• Loosen the screw on the cap (E) using a screwdriver (fig. 3).
• Open the cap (fig. 5).
Connect the power supply unit to the terminal (C) (2-pin input)
•
according to the connection diagrams (fig. 6 to 10).
The power supply unit must be a converter with safety extra-low
voltage (SELV) for LED modules in accordance with EN 61347-1, An-
nex L. The power supply unit must be short-circuit proof (condition-
al or unconditional) or fail-safe.
• Loosen the screw on the opposite cap (F) (fig. 4).
• Open the cap (fig. 5).
• Connect the loads to the terminal (D) (4-pin output) according to
the connection diagrams (fig. 7 to 10).
• Close the LED controller caps again.
• Switch on the power supply to activate the device's pairing mode.
5.3 Pairing
Please read this entire section before starting the pairing procedure.
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the Access Point op-
erating manual.
You can pair the device with either the access point or the Homemat-
ic Central Control Unit CCU3. For detailed information, please refer
to the Homematic IP User Guide, available for download in the
download area of www.homematic-ip.com.
To integrate the device into your system and to enable control via the free
Homematic IP app, you must first add the device to your Homematic IP
Access Point.
Start-up
31