GE AEL06 Manuel D'utilisation Et Instructions D'installation page 10

PREPARE THE AIR CONDITIONER
4
(cont.)
Slide the free end of the accordion panel into
C
the side panel rails. Slide the panel down. Be
sure to leave enough space to slip the top
and bottom of the frame into the rails on the
cabinet.
NOTE: There is a right and a left accordion
panel. Be sure to use the proper panel for each
side.
D Slide the left and right accordion panels into
the top and bottom mounting rails.
Top mounting rail
Top left
Bottom mounting rail
PREPARE THE WINDOW
5
Cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
Installation Instructions
Top right
10
INSTALL THE AIR CONDITIONER IN
6
THE WINDOW
A Place the air conditioner on the sill with the
bottom mounting rail against its back edge.
Center it and close the window securely behind
the top mounting rail. It should be level or
slightly tilted to the outside. Use a level; about
a 1/3 bubble will be the correct case slant to the
outside.
or
Type B screws
B
Extend the left and right accordion panels to
the vertical window sashes and attach, through
the holes in the panels, with 5 Type B screws,
as appropriate.
INSTALL SUPPORT BRACKET AND
7
FOAM TOP WINDOW GASKET
CAUTION:
A
To prevent broken
glass or damage to
windows, on vinyl or other
similarly constructed
windows, attach the
window locking bracket to
the window side jamb with
one Type B screw.
Cut the foam top window gasket to the window
B
width.
Stuff the foam
C
between the glass
and the window
to prevent air and
insects from getting
into the room.
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.
or
Vinyl
Wood