Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Assembly
Assemble all parts as described in the pictures. Whenever you make a
connection make sure to fit the washers first, then the spring washer and
finally the nut.
3.
1.
2.
4.
First start with the antenna clamps (1. & 2.) and then attach the antenna
clamp as well as the mast bracket (mast diameter: 35-60mm) (4.) to the
buffalo pipe (3.) so that all fastening parts are attached to the buffalo
pipe (3.).
5.
(5.) Now mount the antennas to the antenna clamps with the cross
screws. Guide the antenna connections through the opening of the an-
tenna clamp (cable not shown in graphic).
You can vary between different positions per antenna. For use with 4G
LTE 2x2 MIMO we recommend to mount the antennas cross-polarized
(-45° / +45°).
Publicité
Table des Matières
