Publicité
Les langues disponibles
Les langues disponibles
Do not use sharp objects to scrape the frost or electric heating
devices (hair dryers, radiators). The device could be irreparably
damaged.
- After the frost has melted, wipe and dry the freezer compartment
thoroughly.
- Plug it back in and wait an hour or two before filling it again.
Cleaning
• Before cleaning, unplug the appliance.
• Never use abrasive products or a sponge with a scraper for
cleaning the interior or exterior of your appliance.
- Remove all the accessories (shelves, shelves, vegetable bins). Wash
them in lukewarm water with a mild, odorless detergent (dishwashing
liquid, for example), rinse with bleach and dry thoroughly.
- Wash the interior walls in the same way; pay particular attention to the
shelf supports.
- Wash the door seal, also cleaning under the seal.
- Reconnect the device.
• Clean the freezer compartment every time you defrost.
• From time to time, dust off the condenser at the back of the appliance;
An accumulation of dust may reduce the performance of the device.
In case of prolonged absence, empty and clean the appliance; keep
the door ajar during non-use.
Replacing the light bulb
This device is made up of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifespan of these LEDs
is sufficient for no change to be made.
If, however, and despite all the care taken in manufacturing the
refrigerator, the LEDs are defective, please contact your After-Sales
Service for any intervention.
EN-33
Publicité
