Oceanic OCEA1DF193W1 Guide D'utilisation page 61

IV. REVERSE OPENING SENSE
DOOR
You can change the opening direction of your appliance door by
moving the hinges. When reassembling, ensure that the door is
aligned with the body and that the gasket adheres properly.
We remind you that changing the direction of opening the door
must be done with the appliance unplugged.
➢ Remove the plastic screw cover (6) and
the screws (1) that hold the hinge
upper (5) on the body. Remove the
upper hinge (5).
➢ Lift and remove the door. Store
there on a surface that does not risk
spoil it.
➢ Remove the screws (8) which hold the
lower hinge (2). Remove the
lower hinge (2).
➢ Unscrew the left foot (4) and screw the
on the right side.
➢ Position and screw the lower hinge on the left side of the device.
➢ Position the door on the lower hinge (8). Make sure that the door fits
entirely on the rod (9).
➢ Put the door in the 'closed' position. Put the upper hinge (5) in the
new position and replace the screws (1). Be careful, before tightening
the screws (1), check that the door is correctly aligned with the body.
Changing the opening direction of the 4 * freezer door
• Remove the screwed rod (1) at the bottom right.
• Remove the gate.
• Remove the hole cover (2) at the bottom left.
• Unscrew the 2 screws of the lock on the left (3-4).
• Remove the lock (3-4) and position it to the right, tighten.
• Position the gate in the new position, replace the screwed rod
(1) on the left.
• Replace the hole cover (2) on the right.
EN-25