Publicité
Les langues disponibles
Les langues disponibles
III. INSTALLATION
1. Move the refrigerator correctly:
Warning: This operation requires at least 2 people!
- Grasp it, from below, do not pull on the door or on the handle.
- Keep it vertical during transport. Don't knock it upside down. Do not tilt
it more than 45 °.
- Avoid any collision or violent impact.
p
2. Install the refrigerator correctly:
- Install the refrigerator in a dry and ventilated place. Never place it
near a heat source or expose it to direct sunlight.
- Install the refrigerator vertically on a hard, load-resistant base / floor.
Use the adjustable feet to level it.
- Make sure to leave an air space of at least 100mm behind the
refrigerator.
- For your safety, this refrigerator must be connected to a grounded
outlet.
- Install the appliance away from heat sources. If the appliance is
installed in a place of high temperature, under direct sunlight or near
heat sources (radiators, heaters, stoves), the energy consumption will
be higher.
- If possible, please respect the following minimum distances:
➢ 30 cm from stoves or stoves;
➢ 3 cm from electric and / or gas stoves.
- Attach the spacers (if supplied) to the rear of the condenser which is
located at the rear of the device.
- In order to optimize the performance of the device, leave a space 5
cm on the top and make sure that the kitchen elements are far enough
apart to allow good air circulation.
EN-21
Publicité
