Télécharger Imprimer la page

Martin Logan Motion AFX Mode D'emploi page 5

Publicité

Les langues disponibles

Les langues disponibles

er function, please consider the following when
installing your Motion AFX speakers.
• Add Motion AFX speakers in pairs (2 or 4 speak-
ers). If using only 2 Motion AFX they must be
placed with your front left/right speakers. If using
4, they must be placed with your front left/right
and back surround left/right or side surround
left/right if you do not have back speakers.
• Make sure the Motion AFX's output is not
blocked and points at the ceiling and towards
the primary listening position.
• Place the Motion AFX on top of your front or
rear surround speakers or within 3 feet (0.9
meters) of these speakers.
• Place the Motion AFX slightly above ear height.
• Avoid placing the Motion AFX higher than one-
half the height of your ceiling.
• For optimal performance, use the Motion AFX in a
room with a flat ceiling and with a ceiling height of
14 feet (4.3 meters) or less, ideally with a height
between 7.5 and 12 feet (2.3 and 3.7 meters).
• To avoid unwanted proximity effects, place the
Motion AFX, at minimum, 3 feet (0.9 meters)
F
a
requently
Sked
How do I clean my speakers?
Use a dust free cloth (such as a micro fiber cloth)
or a soft brush to remove dust from your speakers.
Do not spray any kind of cleaning agent on or in
close proximity to the drivers .
Could you suggest a list of suitable elec-
tronics and cables ideal for MartinLogan
speakers?
We have no favorites and use electronics and
cables quite interchangeably. We would suggest
listening to a number of brands—and above all
else—trust your ears. Dealers are always the best
source for information when purchasing additional
audio equipment.
All manuals and user guides at all-guides.com
• For extremely detailed setup information we
Note: This speaker is not magnetically shielded
and therefore should not be placed directly beside
or atop a CRT television.
BASS MANAGEMENT
When manually setting up bass management in your
processor or receiver, please set the height chan-
nels to small or 120 Hz if small is not available. The
Motion AFX is not designed for full-range operation.
SPEAKER LEVELS AND CALIBRATION
Some processors and receivers allow adjustment of
speakers levels and room correction/calibration.
To optimize your home theater experience you
should perform these adjustments with the Motion
AFX. For more information please refer to the
instructions for your processor or receiver.
q
ueStionS
Is there likely to be any interaction
between my speakers and the televi-
sion in my A/V system?
Yes. These speakers are not shielded and should
be kept at least 2 feet away from a CRT television.
Will exposure to sunlight affect the life
or performance of my speakers?
We recommend against placing any loudspeaker
in direct sunlight. Ultraviolet (UV) rays from the sun
can cause deterioration of cabinet, speaker cones,
etc. Small exposures to UV will not cause a prob-
lem. Filtering of UV rays through glass will greatly
reduce the negative effects.
from the listening position, and ideally 5 feet
(1.5 meters) or more.
recommend reviewing the Dolby Atmos
guides available on the Dolby website (search
for "speaker setup" on www.dolby.com).
setup
®
5

Publicité

loading