Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Sensor opening and board removal
1.
To remove the cover,
first lift the bottom part
(1) and then unhook it
2
from the upper part of
the guide (2).
2.
two set screws.
A
A
3.
Slide the board until the
notches
the stops
4.
Remove the board.
All manuals and user guides at all-guides.com
1
Remove the
B
A
coincide with
B
.
Wall and pole plate installation
Holes for fixing the
plate to the wall
Holes for fixing the plate
to a pole with adaptor
Installation of the joint
Assemble and fasten
using the Screw D and
B
the Nut E the various pieces
that make up the joint, as shown
in figure, before fixing
the Wall side bracket A
to the wall.
For passing connection
cables and those of the
anti-tampering module,
use the existing space
above the Screw D
- 31 -
mod. SP-OUT
(item 1135106)
C
B
D
F
ATTENTION
ATTENTION
Before fixing the
Position the Sensor side
wall joint, install the
joint C verifying that the
anti-tampering
45° notch is on the
module
bottom and the 90° one
is on the top
E
N
G
A
E
Publicité
Table des Matières
