KRESS Mission KR161E Manuel Du Propriétaire page 16

Troubleshooting
If your Mission RTK
TM
contact your dealer.
Symptom
The LED light on the charging
base does not turn on.
Mission RTK cannot
TM n
correctly dock with the
charging base.
Machine runs out of power
but does not return to
charging base.
When Mission RTK
TM
downhill, it overruns the
boundary line.
After Mission RTK
TM
turned on, the start button is
pressed, but Mission
does not work.
16
EN
Mission RTK does not give
TM n
an alarm when it is outside
the Geo fence.
Mission RTK is parked in
TM n
the middle of the obstacle.
Unable to read log
Mission RTK is parked
TM n
around the wall and
cannot be started, and the
positioning light is always on
red.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
does not work correctly, follow the trouble shooting guide below. If the fault persists,
n
There is no power.
The magnetic strip is placed in
the wrong direction.
No virtual charging base is
mapped.
The length of the magnetic strip
is less than 2.5 m.
is going
n
The angle of the border line is
very sharp.
Mission RTK
TM
is
n
working area.
RTK
TM n
Poor positioning signal
The software of Mission
itself is not the latest.
Mission RTK
TM
The obstacles around Mission
RTK are relatively small, and
n
Mission RTK
TM
of trouble.
The sensor of Mission
abnormal
The format of U-disk is not
FAT32.
Mission RTK
TM
shaded area for too long,
triggering the safety protection.
There are too many walls or
trees in the area, blocking the
positioning signal.
Cause
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Check if the magnetic strip is placed
in the wrong direction. When correctly
placed, the green stripe of the magnetic
strip is facing away from the charging
base.
Rebuild the map and add the virtual
charging base.
The length of the magnetic strip should
be guaranteed to be greater than 2.5 m.
Try to avoid layout scenarios with sharp
angles.
is outside the Move Mission
n
area.
Find an open place, wait for the
positioning signal light to turn green, and
then press start button.
RTK Update the software of the Mission
TM n
RTK
is powered off. Turn Mission
n
TM
Set the area where Mission
fails to get out easily trapped as No-Go.
n
Detect Mission
RTK is
TM n
page on the APP and check the sensor
status.
Convert the format of U-disk to FAT32.
works in the
n
Try to avoid letting Mission
in areas with too much shade.
Solution
RTK inside the working
TM n
.
n
RTK on.
TM n
TM
RTK 's diagnostic
TM n
TM
TM
RTK is
n
RTK mow
n