KRESS Mission KR161E Manuel Du Propriétaire page 12

1
Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your Mission
and put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
turning disc. Failure to use new screws could cause serious injury.
The Mission RTK
TM
mowers. Its cutting blades are razor sharp on 2 edges
and rotate in both directions for maximum cutting
capacity. Redesigned blade profile better prevents grass
clippings from getting caught in the gap between the
disc and the blade. And with new material, the service
life of each cutting blade will be longer than that of
other brands' when it is programmed to mow every
day. Always check to see if the blades are chipped or
damaged and replace them if they are. When the cutting
blades are dull and worn out, they should be replaced
with the spare blades provided with your Mission
RTK . Spare blades are also available at your nearest
n
Kress retailer.
A. Replace the blades
Usually your Mission
12
adjust the frequency of replacing the blade according to the cutting quality of the lawn. When replacing the
EN
blades, make sure to replace all of them at the same time. You can replace them with one of the spare blade
kits and extra blade screws supplied with your Mission
Before attempting to replace your Mission
blades, turn the power off and put on protective gloves
and follow these steps:
1. Gently flip the Mission
2. Remove the battery cover and remove the battery.
3. Take the screws off the blades with a screwdriver.
4. Firmly screw on the new blades.
5. Refit the battery and the battery cover.
Important: After screwing the blade to the blade
disc, make sure the blade is able to spin freely.
does not cut grass like other
n
RTK 's blades need to be reversed each month and replaced every week, you can
TM n
TM
RTK over.
TM n
TM
RTK .
TM n
RTK 's
n
RTK OFF
TM n
1
2