WeatherTech 50279 Instructions D'installation page 2

Installation Steps
3
Reposition the hood shield on the hood with the flanges sliding between the hood and rubber seal. Firmly press adhesive
4
Optional Screw Attachment
5
6
NOTE: Actual application may vary slightly from illustrations.
Remove red tape liner from (6) hood shield flanges to expose adhesive.
tape to adhere hood shield to hood surface.
X6
Install (1) screw with (1) washer through hood shield flange and into hood.
Repeat for remaining locations.
NOTE: Exercise extreme caution not to tear or damage the rubber
seal when seperating from hood.
Use a drill with a 1/8" bit and a 1/2" stop collar to drill a pilot hole at each
flange location. NOTE: Use caution not to drill through the opposite side of
X6
Page 2 of 3
Hood shield
flanges
positioned
BETWEEN
rubber seal
and hood.
the hood!
Hood shield
Washer
Screw
Rubber seal