Eskimo E40 Manuel De L'opérateur page 9

NO. PROBLEM
14 Drilling lights come on, powerhead will not turn, all
(4) battery LEDs indicate a full charge.
15 Drilling lights do not come on, but powerhead
functions normally.
16 Drilling lights stay ON all of the time; must remove
battery to turn them off.
17 Drilling lights come on, powerhead makes a "clicking
noise" from the top of the motor cover, and will not
turn. Battery LEDs indicate a full charge. ("ON" switch
has been held down for more than 5 seconds, battery
core temperature is not frozen). WITH BATTERY
DISCONNECTED, transmission CAN be turned over by
hand, in either direction without stopping.
18 Drilling lights come on, powerhead makes a "clicking
noise" from the top of the motor cover, and will not
turn. Battery LEDs indicate a full charge. ("ON" switch
has been held down for more than 5 seconds, battery
core temperature is not frozen). WITH BATTERY
DISCONNECTED, transmission CANNOT be turned
over by hand in either direction without stopping.
19 Hole count has drastically and quickly reduced. Hole
count cannot be increased by switching batteries or
even powerheads. (The blades are new)
20 Auger jumps on the ice and will not cut.
21 Auger drills a few inches, then spins in the hole.
22 Auger spins at normal speed, but cuts slowly through
the ice.
23 Powerhead functions normally, but hole count is
drastically reduced. Battery indicates a full charge.
Drilling suddenly requires downward force to be
applied to the handlebars in order to cut the ice.
24 Powerhead only runs in forward.
25 Powerhead only runs in reverse.
If above remedies fail, contact Eskimo Customer Service at 800-345-6007 or info@geteskimo.com
Check for parts online at www.GetEskimo.com or call 800-345-6007
POSSIBLE CAUSE
Power switch is not depressed
completely.
LED system has failed or
Controller is not sending
power to the LED system.
LED board has failed.
Eskimo motor is trying to
turn, but cannot due to low
or incomplete voltage to the
motor.
Eskimo motor is trying to
turn, but cannot due to
transmission problems.
Auger bit is damaged or bent. Replace ice auger bit.
Blades are dull or damaged or
re-sharpened incorrectly.
Blades are defective or dull.
Blades are dull or damaged or
re-sharpened incorrectly.
Blades are dull or damaged or
re-sharpened incorrectly.
Reverse switch is faulty
(open circuit) or has
become unplugged inside
the handlebar control, or
Controller is faulty.
Reverse switch is faulty
(closed circuit) or wiring has
become loose on switch and
is touching each other, or
Controller is faulty.
to locate an authorized Service Center near you.
Operator's Manual
Eskimo E40™ Electric Ice Auger
REMEDY/ACTION
Hold the switch for five seconds.
Install LED Light Kit or replace
Controller.
Install LED Light Kit or replace
Controller.
Remove access panel and
Controller. Check connection
between the Controller and
the Motor connector. If all
connections are good, replace
the Controller.
Replace Motor/Transmission
assembly.
Replace with new blades.
Replace with new blades.
Replace with new blades.
Replace with new blades.
Remove handlebar control,
replace Reverse switch or
re-connect wiring. (If switch
and wiring is correct, replace
Controller).
Remove handlebar control,
replace Reverse switch or
re-connect wiring. (If switch
and wiring is correct, replace
Controller).
9