Publicité
Les langues disponibles
Les langues disponibles
1. To activate reverse function, move reverse switch to
"R" and then depress the operating lock and operating
trigger at the same time.
NOTE: Reverse switch is located in front of operating
trigger on top of right grip.
2. To stop the auger, release the trigger.
To flush a hole, do as follows:
1. Place the auger half way down the hole with the auger
starting in the hole. The top of the auger flight must be
above the water and slush.
2. Activate reverse function and continue to lower the
auger into the hole. The lower ring of the auger must exit
the bottom of the hole.
3. After a few seconds of reverse operation, release the
operating trigger.
NOTE: KEEP POWERHEAD CLEAR OF WATER.
Water will come back up the hole and overflow.
4. Repeat the above steps three times to clear the hole.
MAINTENANCE AND STORAGE
Read the maintenance schedule and observe these
recommendations to extend the life of your electric auger.
Good maintenance is essential for safe, economical, and
trouble-free operation. To help you properly care for your
powerhead, the following pages include a maintenance
schedule, routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special
tools, are best handled by professionals and are normally
performed by a technician or other qualified mechanic.
The maintenance schedule applies to normal operating
conditions. If you operate your powerhead under unusual
conditions, such as sustained high-load, or use in unusually
wet conditions, consult Eskimo® customer service for
recommendations applicable to your individual needs and use.
Maintenance and Schedule
MAINTENANCE ITEM
Check bolts and nuts
Charge
Battery
Replace
Sharpen/Replace Blades
Check for parts online at www.GetEskimo.com or call 800-345-6007
Before each
Every 500
Yearly
day's use
charges
X
X
X
Long-Term Storage
If your ice auger will not be run for more than one month,
prepare it for long-term storage.
•
For best results, store your battery with 2 or 3 indicated
lights of charge.
NOTE: You don't need to completely charge your
battery prior to long-term storage.
NOTE: You don't need to charge your battery
during long-term storage unless the charge
drops below 2 lights.
•
Store battery in a cool dry place.
NOTE: Optimal storage temperature is 68° F.
•
Avoid leaving the battery attached to the charger
or powerhead for a prolonged period of time.
Transporting Your Ice Auger
•
Remove the battery if transporting the auger.
SERVICE AND REPAIR
Service Information
At Ardisam, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life
for your auger. Most repairs will be minor, and easily fixed by
following the suggestions in the troubleshooting guide in
this section. The guide will help you pinpoint the causes of
common problems and identify remedies.
For more complicated repairs, contact customer service.
A parts catalog is included with the product separately.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire
about warranty, call or write us at the address found below.
Ordering Repair Parts
Replacement parts can be obtained through our customer
service. Call, e-mail, or order online at www.GetEskimo.com:
Please include the part numbers, part description,
quantity, model number and serial number.
X
Eskimo E40™ Electric Ice Auger
Eskimo Ice Fishing Gear,
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: info@geteskimo.com
Operator's Manual
7
Publicité
