Eskimo E40 Manuel De L'opérateur page 5

BATTERY
GUARD
LITHIUM
BATTERY
AUGER
UNPACKING AND ASSEMBLY
NOTE: Make sure to remove all items from foam packaging.
To Assemble the Battery Guard to the Powerhead
1. Remove the small parts bag containing (1) 3mm hex
wrench, (2) M4 nuts, and (2) M4 bolts.
2. Slide the battery guard into place and secure it with the
included hardware. SEE FIGURE 1
Check for parts online at www.GetEskimo.com or call 800-345-6007
BATTERY
CHARGER
E40
POWERHEAD
PARTS
BAG
FIGURE 1
To Assemble the Auger to the Powerhead
1. Use the hex 3/16" wrench on the powerhead to remove
the bolt from the stem of the auger.
2. Insert the output shaft of the powerhead into the stem of
the auger and align the hole in the stem with the hole in
the output shaft. SEE FIGURE 2
DRIVESHAFT
AUGER
FIGURE 2
3. Replace the bolt in the stem of the auger and tighten
firmly with the included 3/16" hex wrench.
NOTE: There may still be some slop in the connection
between the output shaft and the auger. This is normal.
Optional:
Apply a small amount of oil or grease to the output shaft before
assembly to aid in disassembly at a later date.
IMPORTANT
BATTERY MUST BE FULLY CHARGED BEFORE
FIRST USE. IT IS SHIPPED IN A PARTIALLY
CHARGED STATE.
Operator's Manual
Eskimo E40™ Electric Ice Auger
HEX
WRENCH
POWERHEAD
BOLT
5