Publicité
Meet Philips at the Internet
http://www.audio.philips.com
W
1
1
@
!
0 9
All manuals and user guides at all-guides.com
AZ 1003
CLASS 1
LASER PRODUCT
3140 115 2918.1
2
3
4
8 7
6
CD Player
• CD-RWs, MP3 CD-ROMs, CD-I, CDV,VCD,
1 Adjust the source selector to CD.
2 Insert a CD/ CD-R with the printed side fac-
3 Press PLAY/PAUSE 2; on the set to start
4 To pause playback press PLAY/PAUSE 2;.
5 To stop CD play, press STOP 9.
6 To switch off the set, adjust the source
• Press § once briefly for the next track, or
• Press ∞ once briefly to return to the begin-
• Press ∞ repeatedly for a previous track.
Maintenance
5
• Place the set on a hard and flat surface so
• Do not expose the set, batteries, CDs to
• Do not cover the set. Adequate ventilation
• The mechanical parts of the set contain
• To clean the set, use a dry cloth. Do not use
DVD or computer CDs are not possible for
playback on this set.
ing up and press the CD door gently close.
playback.
Press PLAY/PAUSE 2; again to resume
play.
selector to TAPE/
position and
POWER OFF
check the cassette keys are released.
Note : CD play will also stop when:
- you open the CD compartment;
- you select TUNER or TAPE/
POWER OFF
sound source;
- the CD has reached the end of playback.
Selecting a different track
During playback you can use ∞ / § to select
a particular track.
- If you have selected a track number in the stop
or pause position, press PLAY/PAUSE 2; to
start playback.
press repeatedly until the desired track num-
ber appears in the display.
ning of a current track.
Precautions & General
Maintenance (See 7)
that the system does not tilt.
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
with a minimum gap of 6 inches between the
ventilation holes and surrounding surfaces is
necessary to prevent heat build-up.
self-lubricating bearings and must not be oiled
or lubricated.
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
Tape deck maintenance (See 7)
To ensure quality recording and playback of
the tape deck, clean parts A, B and C as
shown, once a month. Use a cotton bud
Finding a
track
1 During playback
§.
• The CD is playe
ume.
2 When you reco
release ∞ / §.
• Normal playbac
Note : When se
and you reach th
CD goes to stop
Programm
numbers
You may store u
sequence. If you
than once.
1 In the stop posi
programming.
Display show
the program
2 Press ∞ or § t
number.
3 Press PROG to
number.
Display show
briefly follow
32 in seque
program loca
4 Repeat steps 2
desired tracks in
Fu indicate
(when you h
program loca
5 To play your pr
2;.
• Sudden changes
temperature can
lens of your CD
not possible. Do
lens but leave th
until the moistu
• Always close the
on the lens.
• To clean the CD
the center towa
lint-free cloth. D
they may damag
• Never write on
to it.
Publicité
