LENCO CS-455 BT Manuel D'instructions page 7

9. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS
Go to any preset station by pressing one of the 6 preset station buttons (1-6).
If one of these buttons is pressed for more than 2 seconds, the station currently being listened to will be
memorized into the selected preset button.
10. MODE AND PTY (PROGRAM TYPE) BUTTON
Press the MODE/PTY button to change among tuner (radio), disc (when a disc is loaded), SD card (when
an SD card is inserted) , USB (when an USB stick is inserted) and AUX mode.
In Radio mode, Press MODE/PTY button longer to select one of the following mode:
While selecting PTY TYPE, its selection is implemented by preset buttons as described in preset key.
(press one of the 6 preset buttons shortly and repeatedly to select the PTY TYPE in the preset button)
When POP M or NEWS is on, theprevious PTY program and PTY word is displayed on LCD.
If there are no keys entered for 2 seconds, previously selected PTY is searched. During 1 loop, if desired
PTY is not found, NO PTY is flashed, then return to previous normal radioand PTY icon goes off.
11. DISP BUTTON
Press the DISP button briefly to display time for 5 seconds on the display, and then returns to its previous
display unless the button is pressed again.
Press the DISP button l more than 1 second until the clock time flashes, then rotate the VOL knob
to adjust time.
12. AUX INPUT JACK
For connection of other audio device.
13. EJECT KEY
n the power on state, the loaded disc can be ejected by pressing the EJ key.
14. CD SLOT
15. USB SOCKET
When needing to play the file in the USB stick, open the plastic cover cap and insert the USB stick into
the socket. It will switch to the USB mode automatically, and then play the first file in the USB.
When no need to use USB socket, please cover the plastic cover cap.
16. SD CARD SLOT
When you need to play the file in the SD card, insert the SD card into the card slot. It will change into the
SD mode automatically, and then play the first file in the SD.
Note:
When SD card and USB stick are both inserted into their slot or socket, the system will change into
the USB mode automatically.
17. FLASHING LED
18. RESET BUTTON
Before operating the unit for the first time, or after replacing the car battery or changing the connections.
You must reset the unit.
Press this button with a cuspidal object. This operation will erase the clock setting and some stored
contents.
POP M- - NEWS
6