Evermount EM-P1 Instructions page 2

Step Two
Attach monitor brackets to the back of your panel using the appropriate bolts and
washers for your model found in parts bags 1 through 4. Use spacers (N,O) if needed,
between brackets and panel. Ensure that hooks are at the top of the brackets and holes are
at the bottom rear.
Step Three
i.) The wall plate must be installed in a wood stud. Verify stud location.
ii.) Using wall plate as template, and centering it over a stud, mark locations for plate screws
(S) on wall using small holes along bottom and top of wall plate. Ensure that the center
hole is aligned with a stud. All other holes are at 4 inch intervals. At least two of these
holes must align with a stud. Screw wall plate to wall studs.
Step Four
i) With the help of an assistant, lift the entire panel with monitor brackets attached and
place its hooks over the top track of the wall plate. (See figure 2)
ii) Move the monitor into position, so that the holes at the bottom rear of the monitor
brackets align with the holes at the bottom of the wall plate.
iii) Insert the securing rod into monitor bracket hole on the left, ensuring that it also enters
the hole on the wall plate. Pass the rod from left to right, ensuring that it exits through the
monitor bracket hole on the right.
iv) Insert cotter pin (D) into hole at right end of securing rod.
Lag Bolts (S), x 6
Securing Rod
All manuals and user guides at all-guides.com
Studs
Bubble level
Figure 2
Wall Plate
Monitor Brackets
D
2