Beko GN0163040X Mode D'emploi page 92

Installation
3.3. Adjusting the stands
If the product is not in balanced position, adjust the
front adjustable stands by rotating right or left.
In order to adjust the doors vertically,
•Loosen the fixing nut at the bottom
•Screw adjusting nut (CW/CCW) according to the
position of the door
•Tighten the fixing nut for the final position
In order to adjust the doors horizontally,
• Loosen the fixing bolt on the top
• Screw the adjusting bolt (CW/CCW) on the side
according to the position of the door
• Tighten the fixing bolt on the top for the final
position
All manuals and user guides at all-guides.com
3.4. Power connection
A
B
• Our firm will not assume responsibility for any
• The power cable plug must be easily
• Connect the refrigerator to an earthed socket
• Do not use multi-group plug with or without
10 / 38 EN
adjusting nut
WARNING:
Do not use extension or multi
sockets in power connection.
WARNING:
Damaged power cable must
be replaced by Authorized Service.
C
When placing two coolers in adjacent
position, leave at least 4 cm distance
between the two units.
damages due to usage without earthing and
power connection in compliance with national
regulations.
accessible after installation.
with 220-240V/50 Hz voltage. The plug must
comprise a 10-16A fuse.
extension cable between the wall socket and
the refrigerator.
adjusting nut
fixing nut
fixing nut
Refrigerator / User Guide