Manual Tune; Listening To Fm/Am - Teac T-R650 Manuel Du Propriétaire

Select FM or AM by pressing the BAND button repeatedly.
1
2 Select the desired tuning mode.
Each time the TUNING MODE button is pressed, the tuning mode
changes as follows:

Manual tune

<
FM Manual tune
Auto tune
<
FM Auto
Preset tune
<
FM Preset tune
CH01
8

Listening to FM/AM

>
108.00MHz
>
tune
108.00MHz
>
108.00MHz
Select the station you want to listen to.
3
Manual tuning mode
Turn the TUNING/SELECT knob until the station you want to
listen to is found.
The frequency changes by a fixed step (FM: 50 kHz steps, AM: 9
kHz steps).
Auto tuning mode
Turn the TUNING/SELECT knob to begin auto tuning.
When a station is found, the unit tunes in the station
automatically. Repeat this step until the station you want to
listen to is found.
< Press the ENTER button to stop the auto tuning. (on the front
panel of the unit)
< Use the TUNING button (
unit.
Preset tuning mode
See page 9 to 13.
FM Mode
Pressing the FM MODE button alternates between Stereo mode
and Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and "Stereo" is
displayed.
Mono:
Select this mode when the signal is weak. Reception will be
forced monaural, reducing unwanted noise.
) when using the remote control