Makita DGA700 Manuel D'instruction page 13

For United States and Canada
ø45
1
ø78
2
3
ø78
4
Fig.19
► 1. Lock nut 2. Outer flange 78 3. Abrasive cut-off
wheel / diamond wheel 4. Inner flange 78 5. Wheel
guard for abrasive cut-off wheel / diamond wheel
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
Fig.20
► 1. Wire cup brush 2. Urethane washer (included
depending on the country)
Remove the battery cartridge and place the tool upside
down allowing easy access to spindle.
Remove any accessories on spindle. Mount urethane washer
(included depending on the country) then thread wire cup
brush onto spindle and tighten with supplied wrench.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush. It may lead to premature breakage.
Operation with wire wheel brush
Optional accessory
CAUTION:
brush by running tool with no load, insuring that
no one is in front of or in line with the wire wheel
brush.
CAUTION:
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
5
Fig.21
► 1. Wire wheel brush
Remove the battery cartridge and place the tool upside
down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrenches.
NOTICE:
which causes over bending of wires when
using wire wheel brush. It may lead to premature
breakage.
1
MAINTENANCE
2
CAUTION:
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
13 ENGLISH
Check operation of wire wheel
Do not use wire wheel brush that
ALWAYS use guard with wire
Avoid applying too much pressure
Always be sure that the tool is
Never use gasoline, benzine, thinner,
1