KRESS KI200 Mode D'emploi page 9

Automatic
switch down 3 minutes
of instrument
Length ×
width × 120*48*27
height (mm)
Weight (g) 120
1.The measuring range is based on the
default rear reference
2.The measuring range will be reduced
when used in unfavorable conditions
(such as outdoor or excessive ambient
light, poorly reflecting measuring surface,
coarse surface or excessive temperature
difference), which may also lead to a large
deviation.
OPERATING INSTRUCTIONS
9
Initial operation and setup
1. Turning on and off
EN
Long press to turn on/off the
instrument. The instrument switches
of automatically after three minutes of
inactivity.
2. Measure button
Short press to turn on the laser, and
then press again to trigger single
measurement.
3. Return/Clear button
Short press to undo the last action or
clear measured value.
4. Setting measuring reference
The default reference setting is from the
rear of the instrument. Press to
switch the reference point to the front
reference or tripod reference. Press it again
to switch back and forth between the front,
middle and rear.