Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
This chapter summarises the most common problems you could encounter with your iron. If you
are unable to solve the problem, contact the Customer Care Centre in your country.
Problem
The iron is plugged in but the
soleplate is cold.
The iron does not produce any
steam.
Water leaks from the soleplate
during ironing.
The spray function does not
work (specific types only)
Flakes and impurities come out
of the soleplate during ironing.
The automatic shut-off light is
blinking (GC1830 only).
Water leaks from the soleplate
while the iron is cooling down
or after it has been stored.
The steam boost function or
vertical steam boost function
does not work (specific types
only).
All manuals and user guides at all-guides.com
Possible cause
Solution
There is a connection problem.
Check the mains cord, the plug and the
wall socket.
The temperature dial has been
Set the temperature dial to the required
set to MIN.
temperature.
There is not enough water in
Fill the water tank (see chapter 'Preparing
the water tank.
for use').
Set the steam control to position l or ;
The steam control has been set
to position O.
(see chapter 'Using the appliance').
The iron is not hot enough.
Set the temperature dial to a temperature
suitable for steam ironing (2 to MAX).
Put the iron on its heel and wait until the
temperature light has gone out before you
start ironing.
There is not enough water in
Fill the water tank (see chapter 'Preparing
the water tank.
for use').
You have been using hard water,
Use the Calc-Clean function one or more
which has caused scale flakes to
times (see chapter 'Cleaning and
develop inside the soleplate.
maintenance').
The automatic shut-off function
Pick the iron up or move it slightly to
has been activated (see chapter
deactivate the automatic shut-off function.
'Features').
The automatic shut-off light goes out.
The iron has been put in
Empty the water tank and set the steam
horizontal position while there
control to position O before storing the
is still water in the water tank.
iron (see chapter 'Storage'). Store the iron
on its heel.
The (vertical) steam boost
Put the iron in horizontal position and wait
function has been used too
for a while before using the (vertical)
often within a very short
steam boost function again.
period.
The iron is not hot enough.
Set the temperature dial to a temperature
suitable for steam ironing (3 to MAX).
Put the iron on its heel and wait until the
temperature light has gone out before you
start ironing.
ENGLISH
11
Publicité
