Panasonic DOUBLE FEATURE PV-D4745S-K Mode D'emploi page 25

All manuals and user guides at all-guides.com
*Important: If a remote control button does not work when pressed,
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1
Press PROG
to display Program List.
2
Press
to select number.
3
To Replace program...
Repeat Step 2 (p. 24)
to set new programs.
or
To Clear program...
Press ADD/DLT.
4
Press PROG
to end the programming.
Notes
• If you are using a Cable Box, the VCR's channel for Timer Recording must be set to the
Cable Box input channel and Cable Box must be manually set to the desired channel.
Cable Box power must be left on.
• 2 minutes before Timer Recording is performed, "PLEASE PREPARE FOR TIMER REC"
appears and TIMER Light-up Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be
canceled. If "TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION" appears
on-screen, please re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back,
Timer Recording will not be performed.
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
D4745S-K(E) P1-25 (050120).p65
press the VCR button on the remote and try the button again.
To cancel a Timer
Recording in progress...
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
( The TIMER Light-up Indicator
goes out on DECK.)
• Any future daily or weekly recording
will be performed as programmed.
25
25
2005/01/20, 14:02