ENER-J S-71918 Guide D'installation page 10

A camera will not be able to bind to the B account or the C account).
All manuals and user guides at all-guides.com
If other users want to connect to the Smart Floodlight camera, the
primary user needs to share the camera with other users. If you wish
to change the account, the corresponding camera in the A account
needs to be deleted, restore the camera to the factory settings, then
follow the same steps for connecting from the beginning.
9) FAQ
Q : The device cannot be previewed properly?
A :
Check whether the network is normal (2.4GHz). Ensure that you
have placed the camera close to the wifi router, and still if you
face issues then it is recommended to reset the device and add
it again.
Q : Why is it still in the list of devices after resetting?
A :
The reset device only resets the network configuration of the
camera, but cannot change the configuration on the App, remove
the camera, and must be deleted by the App.
Q : How to cut the camera network to another router?
A :
First remove and reset the device on the App and then configure
the device again by the App.
Q : Why doesn't the device identify the SD card?
A :
It is recommended to plug in SD card after the power to the
camera is off. Confirm whether the SD card is normally available
and the format is FAT32. Please note that the TF card can't be
identified when the internet connection speed is not good.
Q : Why I can't get the notifications on my phone App?
A :
Please confirm that the App has been running on the phone,
and the relevant reminder function has been opened; Message
notification and authority confirmation in the mobile phone
system have been opened.
9