CASO DESIGN 3370 Mode D'emploi Original page 77

17.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E-01 Excessive temperature within cooking chamber: The overheating cut-
out terminated the current program at a cooking chamber temperature of
300°C. Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E-03 Sensor fault: The device has detected an error on a sensor and has
terminated the current programme.
Press the Stop button to acknowledge this fault.
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
17.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults
Error
The selected
program will not
start.
The turntable turns
jerkily.
Food is not
sufficiently
defrosted, warmed
up or cooked after
preset time has
elapsed.
The device
functions but the
cooking chamber
lighting does not
work.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable
and the base of cooking
camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
Defective cooking chamber
light.
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
Have Service dept repair cooking
chamber light.
77