Bosch GBH18V-20 Consignes De Fonctionnement/Sécurité page 9

2610048709.qxp_GBH18V-20 6/19/17 12:41 PM Page 9
switch in the locked or off position before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
FIG. 2
3
1
2
switch in the locked or off position before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING & REMOVING 3-JAW CHUCK
(Not included, available as accessory)
The 3 Jaw Chuck
with SDS Shank
can convert your
tool for use with
straight shank
bits (Fig. 4).
Clean the insert
shank end of the accessory to remove any
debris, then lightly grease with a light oil or
lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
All manuals and user guides at all-guides.com
Assembly
Disconnect battery pack
from tool or place the
®
ACCESSORIES
DUST
SHIELD
Disconnect battery pack
from tool or place the
FIG. 4
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING SDS-plus
Accessories may be hot
after use. Avoid contact
with skin and use proper protective gloves or
cloth to remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
FIG. 3
LOCKING
SLEEVE
1
2
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 5).
To remove the chuck, pull the locking sleeve
backward (towards the rear of tool), while
pulling the chuck forward.
FIG. 5
3-JAW CHUCK
(Not included, available
as accessory)
1
-9-
®
ACCESSORIES
3
LOCKING
2
SLEEVE