BEMIS BIOBIDET BB-500 Mode D'emploi page 7

5. Connect the Water Hoses
a. Install the t-valve onto the toilet tank. Ensure the cone washer
is properly seated inside the t-valve.
b. Connect your existing toilet hose to the water shut-off and t-valve.
c. Connect the bidet hose to the bidet seat and t-valve.
d. Open the water shut-off valve. Check for any leaking or dripping.
Use a wrench to tighten any loose connections.
e. Plug the power cord into a dedicated 120V power outlet.
Shut-off valves may vary. If supplied parts do not fit, please call
847.458.2334. Alternate fittings may be available upon request.
Toilet Tank
Cone Washer
*Inside T-valve
T-Valve
Toilet Hose
12
Cleaning the BB-500
•
•
Cleaning the Nozzle
Gently pull out the nozzle.
Dip a soft cloth, sponge, or
small brush into a neutral
cleaning solution.
Use the cloth, sponge, or brush
to carefully wipe the nozzle.
Use During Power Failure
During a power outage, it is not possible to adjust the water
and seat temperature. However, you can still use the bidet
Bidet Hose functions with ambient water.
Resetting the BB-500
Shut-off Valve
Press and hold the reset/drain
button for 2 seconds.
When you clean this product, do not use thinner, benzene
or toilet bowl cleaner, as it may cause discoloration or damage.
Disconnect the power cord and use a wet cloth when you
clean this product.
13