Configure Bd Veritor™ Infowifi; Install Wi-Fi Module - Bd Veritor Plus System Mode D'emploi

4 Configure BD Veritor™ InfoWiFi
4.1

Install Wi-Fi module

1 Refer to the BD Veritor™ Plus System InfoWiFi Quick Reference Guide for instructions on
installing the BD Veritor™ InfoWiFi Module into the analyzer slot.
2 Plug in the DC power supply connected to a wall outlet.
3 Hold the analyzer as shown. Press the power button and scan the Configure Wireless Network
barcode below the image. The scanner will be active for 2 seconds while "SCAN CONFIG
BARCODE" is shown on the display.
If the configuration barcode is not scanned within approximately 2 seconds, the BD Veritor™
Plus Analyzer will enter normal operation mode. Power off the BD Veritor™ Plus Analyzer and
power on to reattempt scanning the barcode.
9