Worx CONTOUR WX461 Traduction Des Instructions Initiales page 10

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Waste electrical products should
10
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or retailer for
recycling advice.
Jigsaw
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for sawing wood,
plastic, metal and building materials while
resting firmly on the workpiece. It is suitable
for straight and curved cuts with mitre angles
to 45°. The saw blade recommendations are to
be observed.
1. ON/OFF SWITCH (See Fig. A)
The tool is switched on by the switch button
located at the side of the motor housing. The
switch locks in the on position, a convenience
for continuous operation.
TO TURN ON THE TOOL on slide the switch
button forward.
TO TURN OFF slide the switch button
backward.
2. VARIABLE SPEED CONTROL
(See Fig. B)
Adjust the Variable speed control to increase
or decrease the speed according to the
material, material thickness and blade
specification to be used (also possible during
no load operation). See Chart 1 for general
guidance on speed selection. Avoid prolonged
use at very low speed as this may damage
your jigsaw's motor.
Chart 1
Material
Wood
Metal
Aluminum
PVC
Ceramic
3. HAND GRIP AREAS
Always ensure you maintain a firm grip whilst
operating your jigsaw. Your hand must hold
on the handle when you are working.
Speed setting
5-6
3-4
3-5
3-4
3-5
EN