Publicité
Les langues disponibles
Les langues disponibles
2. Complete Vacuum Breaker Installation
NOTE: Do not install the shroud until the roughing-in and finishing
is complete.
Lubricate and insert one O-ring into each outlet port and inlet
port on the vacuum breaker.
Slide the vacuum breaker assembly into both sleeves at the same
time. Secure with two socket screws. Tighten the socket screws
with a 5/32" hex wrench. Do not overtighten.
Rotate the shroud so the opening faces the back. Slide the shroud
over the vacuum breaker assembly. Ensure that the threaded pin
comes through the hole at the top of the shroud.
Thread the shroud cover onto the threaded pin until hand tight.
Kohler Co.
All manuals and user guides at all-guides.com
Cover
Slot
Shroud
Threaded Pin
5
1034416-2-A
Publicité
