Joyor F Série Mode D'emploi page 14

Joyor User Manual
USB Charging Indicator
The display is equipped with a USB port for you to be able to charge your electronic devices. When the device is connected, the
USB indicator is lit. In cae of problem the indicator starts to flash, and a safety mode will be automatically activated.
Parameter Settings
Long press the M and ON/OFF at the same time to enter into the parameter settings mode. Short press the ON/OFF button to
switch between parameters. Short press M to change the settings. Long press the M and ON/OFF at the same time to save and
exit
P01: rear light brightness: 1 - the darkest, 3 - the lightest;
P02: mileage unit, 0: km; 1: mile;
P04: sleep mode time: 0 - no sleep mode; 1-60 - sleep mode, minutes;
P06: wheel diameter: unit - inch; precision: 0.1;
P07: number of measuring magnets: range 1-100;
P09: zero start, non-zero start setting: 0 - zero start; 1 - nonzero start;
P12: starting torque: range 0-5, 0 - the weakest, 5 - strongest;
P15: motor drive signal percentage settings: full speed is set to 100
P16: cruise control function: 1 - activated, 0 - deactivated
P17: light settings: the lights are not lit automatically when the vehicle is on, 0 - the lights are lit automatically when the vehicle is
on
P99: settings reset (when in P99 settings, press and hold the MODE button for 5-6 seconds to reset all the parameters back to the
initial settings)