Publicité
Les langues disponibles
Les langues disponibles
CONNECTING THE INLET HOSE
Method 1
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. If space permits, attach the brass female end of the "Y"
connector to the cold water faucet.
2. Turn the cold water faucet off .
3. Attach the straight end of long hose to the "Y' connector.
4. Using pliers, tighten the coupling with an additional two-
thirds turn.
5. Attach the angled end of long hoses to fi ll the valve at the
bottom of the dryer's rear frame. Screw on the coupling by
hand until it is seated on the fi ll valve connector.
6. Using the pliers, tighten the coupling with an additional two-
thirds turn.
7. Check that the water faucets are on.
8. Check for leaks around the "Y" connector, faucets and
hoses.
DV455_02836F-08_EN.indd 19
DV455_02836F-08_EN.indd 19
All manuals and user guides at all-guides.com
Do not overtighten, as this may damage the coupling.
Do not overtighten, as this may damage the coupling.
English - 19
Y-Connector
Water Hose
Duct Exhaust
Frame
(back)
Water Hose
2013-12-12
2013-12-12
5:11:55
5:11:55
Publicité
