Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Choose a Location
•
Locate the freezer so that extension cords are not
necessary.
•
Your freezer operates most efficiently when located in an
area where the temperature is normally between 4°C
(40°F) and 32°C (90°F).
•
Allow 3 inches (7.5 cm) between overhead cabinets
and the upright freezer top. Allow at least an inch (2.5
cm) between the back of the freezer and the wall.
•
Allow 1 inch (2.5 cm) on each side of the freezer for
ease of installation.
If the side of the freezer is to be against a wall, you will
•
need to leave enough space so the door can be
opened.
•
Be sure to install your freezer on a floor strong enough
to support it when it is fully loaded. The freezer must
be solidly positioned on the floor if it is to function at its
best. The front levelling legs may be used to accom-
plish this wherever the floor is too uneven.
•
If the location selected for your freezer is damp or
moist, as in some basements, the use of 2x4's is
recommended to ensure adequate support. Make sure
the 2x4's are placed directly under the feet of the
freezer.
Install Properly
All manuals and user guides at all-guides.com
- 6 -
Level Your Freezer
You can level your freezer with
the screw-type adjustable
leveling legs located at the front
corners or the base.
Remove Packaging Material
Remove all shipping tape and cardboard inside and
outside the freezer. If there is adhesive residue left on the
freezer, it may be removed with warm water and mild
detergent. Do not use a solvent such as lighter or
cleaning fluid, or an abrasive cleaner which may harm
the finish.
As you remove the tape and cardboard, check for
accessory items.
Clean the freezer interior and parts to remove dust from
shipping and packaging. Clean the inside of the freezer
with a mild detergent.
Electrical Supply
The freezer should always be plugged into its own
individual 120V, 60 HZ electrical grounded outlet, which is
protected by its own 15 ampere fuse or circuit breaker.
This is recommended for best performance to prevent
overload of house wiring circuits, which could cause a
possible fire hazard by overheating wires.
Do not plug the freezer into an outlet controlled by a
wall switch or a pull cord which may be turned off
accidentally.
Properly Polarized and
Grounded Outlet
Three-Pronged (Grounding) Plug
If the electrical outlet you intend to use will not
accept the three-prong plug, you must have a
properly grounded three-prong outlet installed by a
qualified electrician. Do not, under any
circumstances, cut or remove the round grounding
prong from the plug.
Publicité
