Hinkley 48 CHET Manuel D'instructions page 8

HANGING THE FAN
WARNING: Make sure the cross pin is installed well on hanger ball with downrod.
Remove hanger ball from downrod by loosening set screw in the side of
1
the hanger ball. Slide hanger ball down and remove cross pin. (Fig. 1)
Carefully support fan body (motor) in its packing with the mounting collar
2
(where the wires come out) facing upward.
Loosen the security set screw and remove the downrod pin and cotter pin
3
from the coupling on top of the motor assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable from the fan
4
through the downrod. Thread downrod into coupler until holes align. Insert
downrod pin through holes in mounting collar and downrod; clip cotter pin
through small hole in end of downrod pin to hold downrod in place.
Securely tighten set screw against downrod using a large flat-head
5
screwdriver to ensure a tight fit against downrod. Tighten nuts against
mounting collar.
6 hinkley.com
Hanger ball
Figure 1
Downrod
Moumting Collar
Cotter pin
Top of Fan Body
Figure 2
Cross pin
Set screw
Downrod
Hook-up (3) Wires
Security Screws
Downrod pin