Nanosonics trophon Mode D'emploi page 8

Printer – Initial Set-Up
1.3
 Unpack the printer from its packaging
 Position the printer securely on a bench beside the trophon EPR. The printer Wall Mount or
printer Cart Mount accessory should be used to mount the printer to the wall or cart.
 Follow the setup instructions in Appendix A below for powering on the printer and connecting it to
your trophon EPR.
NOTE: Ensure the printer power cable is connected to the printer before connecting to an earthed
mains outlet or switching power switch to on position.
NOTE: Keep the label roll holders in the "unlock" position. Please note the orientation of the label roll
holders in Figure 3, as they can be rotated. Incorrect orientation will prevent correct loading of the label
roll into the printer.
2. INSTRUCTIONS FOR USE
 Once the printer is connected to the trophon EPR via the cable provided and powered on, the
printer will be automatically detected.
 It is recommended that a Test Print is completed as the initial printed label. Complete a test print
by selecting Menu
The printer will print and cut a sample label, confirming correct connection.
 The number of printed label record copies (1-4) can be selected for each disinfection cycle.
Select Menu  Printer  Number of Labels  1 – 4 on the trophon EPR screen.
 Printed label records will be available at the completion of each trophon EPR HLD cycle.
NOTE: Records of the previous high level disinfection cycle can be re-printed from the printer by

selecting Menu Printer
3. ROUTINE CARE AND MAINTENANCE
3.1 Replacing printer Label Roll
The trophon EPR will display a notification when the label roll requires replacement via the screen
message: Printer out of Paper.
Follow the setup instructions included in Appendix A to load the label roll.
3.2 Cleaning the Printer
 Turn off the printer and unplug from the power socket before cleaning.
 Do NOT submerge the printer, or pour liquids over it.
 Keep the power socket completely dry (see Figure 2).
 Remove the label roll paper from the printer prior to cleaning the printer.
 Clean the printer feeder area routinely to ensure there is no glue or paper residue. Use tweezers
to remove any excess residue from the paper cutter area.
 For cleaning, wipe the outside covers of the printer with a cloth moistened with a mild, soapy
solution, until all surfaces are visibly clean, taking care to ensure that liquid does not come into
contact with the power socket, interior of the printer , or label roll.
 For disinfecting, wipe all external surfaces of the printer with an Isopropanol or Quat Wipe.
 Clean the printer head when replacing the label roll using a soft cloth with ethanol. Refer to
Figure 3 for printer head location.
L00052 2.0 01/2017
All manuals and user guides at all-guides.com
 
Printer Test Print on the trophon EPR screen.

Reprint Last Record.
6