Launch CReader Serie Guide De Démarrage Rapide page 3

CReader Series
2. Register & Update (Cont'd)
4. The Register Code can be found in
your tool. Connect one end of the
USB cable to your tool, and the other
end on the computer.
5. After the tool has powered up and
entered the main menu screen, move
the highlight bar on the "Help" icon
and press [OK].
6. Highlight the "Tool Information" in
Fig. 4 and press [OK].
7. The Register Code shown in Fig. 5 is
the Register Code needed in step 3.
(Return to step 3 and input the Register
Code and then proceed)
8. Install the memory card from the tool
into the supplied USB memory card
adaptor and insert into the USB port
of the computer.
9. Reopen the update tool, select the
updates you would like to perform or
click "Select All", and then click
[Download] to start downloading.
(Note: For CR910, only one piece of
diagnostic software can be selected and
downloaded.)
10.Once all steps are complete, reinsert
the memory card into the tool
and power the tool via USB cable or
via OBD II cable. A dialog box (Note:
If only diagnostic software is updated
and no firmware package is downloaded,
All manuals and user guides at all-guides.com
Quick Start Guide
Help
DLC Location Information
DTC Library
Abbreviation
Tool Information
About OBD
3/5
Tool Information
Boot version:
V02.01
Display program version:
V02.00
Diagnostic program version:
V11.23
Diagnostic library version:
V11.28
Serial Number:
974990000001
Register Code:
Register Code:
4d001e001151 4d001e001151
-Exit
2. Register & Update (Cont'd)
4
this box will not appear) prompting you to
update will pop up on the screen (See Fig. 6),
select [OK].
11. The registration process is complete, your
tool is now ready for use.
Method 2: Via USB Cable
Note: Make sure the computer has an Internet connection.
1. Connect one end of the USB cable to the USB port of computer, and
the other end to the tool.
2. If a newer version is found, a screen similar to Fig. 7 appears.
3. Press [OK] to configure this tool as a USB device. See Fig. 8.
(Note: The Serial Number and Register Code shown in this figure are
needed for inputting in Steps 4-6.)
5
Boot Version: V10.02
Serial Number:
974990000001
Register Code:
4d001e001151
Check for new version?
Note: Internet connection is
required for PC.
Yes – OKAY No – ESC
4
4. Launch the update tool, a screen similar to Fig. 9 will appear.
5. Type in the Serial Number. Click [Device Upgrade] to input the
information and click [Submit] to enter the update page.
System upgrade
Sure upgrade?
7
Boot Version: V10.02
Serial Number:
974990000001
Register Code:
4d001e001151
Caution:
DO NOT disconnect USB
while downloading.
The unit should be re-powered
after download new version.
LAUNCH
6
8
EN