Publicité
INSTALLATION: Option 1
STEP 1: Turn OFF power before installation,
then remove the rubber plug and loosen
two screws.
STEP 2: Remove the 1/2" inner cap.
STEP 3: Peel off the yellow sticker on gasket and
paste it on the round area of the bottom plate.
STEP 4: Fix the bottom plate on the round plate.
STEP 5: Connect the wire with power input line
by three connectors, refer to wiring diagram.
STEP 6: Plug in battery pack to the emergency
driver port.
STEP 7:
with the two screws. Cap the screw holes with
rubber plugs.
STEP 8: Be sure all connections are protected,
then turn ON power.
Bypassable Photocell
To bypass photocell, unplug from connection
board.
INSTALLATION: Option 2
STEP 1: Turn OFF power before installation,
then remove the rubber plug and loosen
two screws.
STEP 2: Remove the 1/2" end cap.
STEP 3: Peel off the yellow sticker on gasket and
paste it on the round area of the bottom plate.
STEP 4: Fix the bottom plate on the round plate.
STEP 5: Connect the wire with power input line
by three connectors, refer to wiring diagram.
STEP 6: Plug in battery pack to the emergency
driver port.
STEP 7:
with the two screws. Cap the screw holes with
rubber plugs.
STEP 8: Be sure all connections are protected,
then turn ON power.
Bypassable Photocell
To bypass photocell, unplug from connection
board.
1
3
5
1
3
5
2
2
4
6
2
4
6
Publicité
