Satco Nuvo 65-095 Instructions Pour L'installation

INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: READ BEFORE INSTALLING FIXTURE. RETAIN FOR FUTURE REFERENCE.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances.
Proper grounding is required to insure personal safety. Carefully observe grounding procedure under installation section.
WARNING: Make certain power is OFF before starting installation or attempting any maintenance. Risk of fire/electric shock.
If not qualified, consult an electrician.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened firmly.
Apply weatherproof silicone sealant around the edge of the Back Box and/or Junction Box. This is especially important with an
uneven wall surface. Silicone all plugs and unused conduit entries.
SURFACE MOUNT FOR RECESSED BOX
For use with recessed junction box and wiring.
1. Use supplied crossbar. Mount crossbar to
recessed junction box with (2) screws.
2. Place gasket on back of the fixture. Gasket
should create seal against mounting surface.
3. Wire fixture to supply wires in recessed box
according to wiring section.
4. Use 1/4 x 20 stainless steel mounting screw to
attach fixture to Crossbar. Tighten mounting screw.
5. Cover screw with cap, provided.
6. Fixture can be mounted as an up-light in
dry and damp locations only.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized.
1. Clean glass lens with non-abrasive glass cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the LED.
WIRING
All units may operate at 100V to 277V, 50 or 60Hz.
1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (–) COMMON supply lead.
3. Connect the bare copper Ground wire from fixture to supply ground.
TROUBLESHOOTING
1. Check your power source.
2. Check electrical connections.
3. Check that the photo cell or motion sensor is working properly (if so equipped).
© Copyright 2016 Satco Products, Inc. 6/17
Models: 65-095, 65-096, 65-201, 65-202, 65-205, 65-206
LED Slim Wall Pack
Satco Products, Inc.
Brentwood, NY 11717