Techno Line WS8086 Mode D'emploi page 16

Trouble shooting
If your clock displays irrelevant time or does not function properly,
which maybe caused by electro-static discharge or other
interference. Unplug the DC jack at the back of the unit, open the
battery cover and take out the batteries. Then re-plug the DC jack
and reinstall batteries by observing the correct +/- polarity. Your
unit will be reset to default settings and you need to set it again.
Hereby, Technotrade declares that this product WS 8086 is in
compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The
original EU declaration of conformity may be found at:
www.technoline.de/doc/4029665080864
Specifications
Default settings:-
Time
Sound sensor sensitivity
Care of the product
1. Place your unit on a stable surface, away from sources of
direct sunlight or excessive heat or moisture.
2. Protect your furniture when placing your units on a natural
wood and lacquered finish by using a cloth or protective
material between it and the furniture.
3. Clean your unit with a soft cloth moistened only with mild soap
and water. Stronger agents such as Benzine, thinner or similar
materials can damage the surface of the unit. Make sure the
unit is unplugged before cleaning.
4. Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
5. If the unit is not to be used for a prolonged period, such as a
month or longer, remove the batteries to prevent possible
0:00, 24HR format
LO
EN6