Publicité
Les langues disponibles
Les langues disponibles
B
❸
Then screw an M6-16 mm
on top of the front
B
wing. Tighten firmly.
MOUNTING THE STAB
❶
Connect the stab to the fuselage.
MOUNTING THE FOIL ON THE BOARD
K
H
SCS nuts for inflatable board HIPE
H
SCS nuts for Rigid Board
K
EN
A
❷
Finally lock the assembly with the M6-12 mm
screw underneath. Tighten firmly.
A
❷
Use the 2 provided M6-16 mm
to fix it. Tighten
B
firmly.
- 18
>⃝●
Assemble the 2 rapid Smart Connection System (SCS) brass nuts with the 4 appropriate M6 screws
(see correspondence table below) and the washers on the top plate of your mast without tightening them.
Use the closed brass nuts with a HIPE inflatable board to avoid any risk of damage caused by screws
that are too long.
❶
>⃝●
Flip your board on its deck on a smooth surface and protect the nose and tail.
❶
Flip your foil mounted with its top plate and its SCS brass nuts above your board and insert it in the rails of
the board. Press firmly on the screws.
❷
Slide the foil backwards up to the desired position. If the foil is blocked and cannot slide in the rails, slightly
unscrew the 4 screws then try again.
❸
Firmly tighten the 4 screws of the top plate.
>⃝●
Once the previous steps have been completed, the foil is mounted on the board and ready for action.
GONG-GALAXY.COM
GONG-GALAXY.COM
EN
❷
ANY QUESTIONS ? Contact our team
gong-galaxy.com/en/help-contact/
- 19
❸
Publicité
