Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
WARNING! Do not install the battery pack
before it has been completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully. Remove the chain cover
by turning the chain tensioning knob in a counter-
clockwise direction. (See Fig. A1)
A1
2
2. Place the Chainsaw on a solid, level surface.
3. Use only genuine Kress chains or those
recommended for Guide Bar.
EN
4. Slide the chain in the slot around the guide bar.
Ensure the chain is in correct running direction by
comparing it to the chain icon on the guide bar, or
referring to the chain direction symbol found on
the saw body. Ensure the bar tensioning plate is
facing outward. (See Fig. A2)
A2
24
5. Fit the chain onto the drive sprocket, so that the
fastening bar bolt and the two bar locating tabs on
the bar pad fit into the keyway of the opening on
the guide bar. (See Fig. B1, B2)
6. Assure all parts are seated properly and hold
chain and guide bar in a level position. Make sure
the drive links are fully seated in the drive sprocket
(See Fig. C1), avoiding a kink as shown in Fig. C2.
If kink occurs, pick up on the chain at the guide
bar just ahead of the kink and then pull the kink
out.
12
NOTE: Chain should rotate freely and be free of
kinks.
B1
B2
1
C1
7. Fit the chain cover and tighten the chain cover by
turning the chain tensioning knob clockwise until it
is tight. (See Fig. D)
8. The chain will stretch while cutting and lose
proper tension. When the chain becomes loose,
completely unscrew the chain tensioning knob
or turn the knob around three (3) full turns in a
counter-clockwise direction, then retighten the
chain tensioning knob to properly reset the chain
tension by repeating Steps 6-7 listed above.
1
WARNING: The chain is not yet tensioned.
Tensioning the chain applies as described
2
Publicité
