ARDES AR5PR4001 Mode D'emploi page 16

Batteries
Remote control is supplied with battery inside (CR2025 type, 3V); remove
the transparent sheet from the battery cover before use remote control.
When the battery is over, it must be replaced with the same type.
To remove battery, follow the drawing on the back of remote control.
ON/OFF Button (A)
Press this button when the unit is off to turn it on.
Press this button when the unit is on to turn it off.
SPEED Button (B)
Press this button when unit is on to select the desired speed: low speed
(display will show "P1"), medium speed (display will show "P2") or high
speed (display will show "P3").
TIMER Button (C):
When the unit is operating, you can set the timer to switch the fan off
automatically after the set time. Press this button repeatedly to select the
desired time period in one hour increments from 1 hour to 9 hours.
The display will show the setted time in hours. To deactivate the timer
function press timer button till the display will show "P1", "P2" or "P3" or
turn the fan off manually.
OSC Button (D)
Press this button when unit is on to activate the automatic oscillation
from left to right. To deactivate the automatic oscillation press again this
button.
SLEEPING Button (E)
Press this button when unit is on to activate the sleeping mode (low and
variable speed).
Press this button again to turn the sleeping mode off.
DISPLAY Button (F) - only on remote control
Press this button when unit is on to turn the display light off; press again
to turn the light of display on.
VERTICAL SLOPE
You can vertically point the front of the fan
choosing the desired angle. It is sufficient to
move the front of the fan up or down according
to the desired slope.
16