Publicité
Les langues disponibles
Les langues disponibles
SERVICE AND ADJUSTMENTS
1. Remove knob and carriage bolt on one side of the
lower handle.
2. While holding handle assembly, remove knob and
car riage bolt from opposite side, align hole in handle
with desired hole in handle bracket and reassemble
bolt and knob and tighten securely.
3. Align opposite side of handle with same positioning
hole and secure with bolt and knob.
KNOB
HANDLE
BRACKET
Immediately prepare your mower for storage at the end of
the season or if the unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a period of time, clean
it thoroughly, remove all dirt, grease, leaves, etc. Store in
a clean, dry area.
1. Clean entire lawn mower (See "CLEANING" in the
Maintenance section of this manual).
2. Lubricate as shown in the Maintenance section of this
manual.
3. Be sure that all nuts, bolts, screws, and pins are securely
fastened. Inspect moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint surfaces; sand
lightly before painting.
HANDLE (See Figs. 21 and 22)
You can fold your lawn mower han dle for storage.
1. Loosen the two "star" handle knobs on sides of the
upper handle and allow handle to fold down to the rear.
2. Loosen the two "standard" handle knobs on sides of
the lower handle and pivot entire handle as sem bly
forward and allow it to rest on mower.
3. Reinstall "standard" knobs and carriage bolts to lower
handle or handle brackets for safe keeping.
•
When setting up your handle from the storage posi-
tion, you must manually lock lower handle into mowing
position.
IMPORTANT: WHEN FOLDING THE HANDLE FOR STORAGE
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.
BOLT
HIGH
MEDIUM
FIG. 20
STORAGE
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to
increase engine speed or it may result in personal injury. If
you believe that the engine is running too fast or too slow,
take your lawn mower to a Husqvarna or other qualifi ed
service center for repair and ad just ment.
CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your lawn mower to a Husqvarna or other authorized
service center for repair and/or adjustment.
IMPORTANT:
GOVERNOR, WHICH IS FACTORY SET FOR PROPER
ENGINE SPEED. OVER SPEED ING THE ENGINE ABOVE THE
FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF
YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS
LOW
ADJUSTING, CONTACT YOUR NEAREST HUSQVARNA
OR OTHER AUTHORIZED SER VICE CEN TER, WHICH HAS
PROPER EQUIP MENT AND EXPERIENCE TO MAKE ANY
NEC ES SARY ADJUSTMENTS.
OPERATOR
PRES ENCE
CONTROL
BAR
KNOB
15
NEVER TAMPER WITH THE ENGINE
FOLD
FORWARD
FOR
STORAGE
LOWER HANDLE
"STANDARD" KNOB
FIG. 21
BOLT
FIG. 22
MOWING
POSITION
UPPER
HANDLE
UPPER
HANDLE
"STAR"
KNOB
LOWER
HANDLE
HANDLE
BRACKET
Publicité
