STEINEL IR 180 UP easy Information page 13

The stay-ON time s restarted by any movement before this time elapses. The
shortest time setting is recommended when adjusting the detection zone and
performing the functional test.
Note: every time the light switches OFF, it takes approximately 6 seconds for
the sensor to start detecting movement again. Only after this time elapses can
the sensor switch turn light ON again in response to motion.
LED ON/OFF
If you are irritated by the status LED, it can easily be switched OFF.
Briefly (1 second) set control dial to LED ON/OFF.
LED flashes once: LED is ON.
LED flashes twice: LED is OFF.
The control dial must then be adjusted to the chosen time setting. If this is not
done, the time set is 2 minutes.
Switch for light function (Fig� 6�2/H)
Light ON status: press once
Light goes out. If no movement is being detected, the stay-ON time elapses and
the sensor switches to normal sensor mode.
Light OFF status: press once
Light come ON even in sufficient ambient brightness. The light stays switched
ON until the sensor switch turns it OFF because no movement is being detected
or ambient brightness is sufficient.
Teach mode
Teach mode saves the current ambient light level below which you do not want
the sensor to respond to movement from now on.
Pressing the button for 5 seconds programs in the light level. This takes place
5 seconds after releasing the button to prevent any shadow being cast over
the brightness sensor. The LED flashes once to indicate that Teach mode has
been selected. The connected lamp is switched OFF while the Teach cycle is in
progress. The LED flashes once to confirm that the current ambient light level
has been saved. The sensor switch then returns to sensor mode and operates
with the new threshold. Teach mode can be repeated any number of times.
To quit Teach mode, turn the twilight setting control dial.
G B
1
Y E A R
MANUFACTURER'S
WARRANTY
- 24 -
7� Maintenance and care
This product requires no maintenance.
The surface can be cleaned with a damp cloth (without detergents) if dirty.
8� Disposal
Electrical and electronic equipment, accessories and packaging must be recy-
cled in an environmentally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste Electrical and Electronic Equip-
ment and its implementation in national law, electrical and electronic equipment
no longer suitable for use must be collected separately and recycled in an
environmentally compatible manner.
9� Manufacturer's Warranty
This STEINEL product has been manufactured with great care, tested for
proper operation and safety in accordance with applicable regulations and
then subjected to random sample inspection. STEINEL guarantees that it is in
perfect condition and proper working order. The warranty period is 36 months,
starting from the date of sale to the consumer. We will remedy defects caused
by material flaws or manufacturing faults. The warranty will be met by repair or
replacement of defective parts at our own discretion. The warranty shall not cov-
er damage to wear parts, damage or defects caused by improper treatment or
maintenance. Further consequential damage to other objects shall be excluded.
Claims under warranty shall only be accepted if the product is sent fully
assembled and well packed complete with receipt or invoice (date of purchase
and dealer's stamp) to the appropriate service centre or handed in to the dealer
within the first 6 months.
Repair service:
Please ask your nearest service centre how to proceed for repairing faults not
covered by the warranty or occurring after the warranty expires.
5
3
Y E A R
MANUFACTURER'S
WARRANTY
Y E A R
MANUFACTURER'S
WARRANTY
- 25 -