Techno Line WS 8006 Manuel D'instructions page 7

Reception of the Radio signal:

The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of new fresh batteries.
The radio mast icon starts to flash.

At 1:00 am, the clock automatically carries out the synchronization procedure with the DCF signal to correct any
deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon disappears from the
display), the system will automatically attempt another synchronization at the next full one hour. This procedure is
repeated automatically up to total 5 times.

To start manual DCF signal reception, press the "WAVE" button. If no signals received within 7 minutes, then the DCF
signal search stops (the radio mast icon disappears) and start again at the next full one hour.

During RC reception，to stop searching radio signal, Press and hold the "WAVE" button for two seconds.
Notes:

A flashing radio mast icon indicates that the DCF signal reception has started

A continuously displayed radio mast icon indicates that the DCF signal was received successfully

We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer
monitors

Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme circumstances,
place the system close to the window.
Hereby, Technotrade declares that this product WS8006 is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of conformity may be
found at: www.technoline.de/doc/4029665080062
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the reception is maybe
affected by the following circumstances:

long transmitting distance

nearby mountains and valleys

near freeway, railway, airports, high voltage cable etc.

near construction site

among tall buildings

inside concrete buildings

near electrical appliances (computers, TV's, etc) and metallic structures

inside moving vehicles
Place the clock at a location with optimal signal, i.e. close to a window and away from metal surfaces or electrical
appliances.
Precautions

This main unit is intended to be used only indoors.

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components of this unit.
Batteries safety warnings

Use only alkaline batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.
EN3