Techno Line WS 8006 Manuel D'instructions page 5

Functions:

Radio controlled clock

Manual time setting

Time zone setting: -12/+12 hour difference

Continuous calendar up to year 2099

Temperature display in °C or °F

Two daily alarms

Time in optional 12/24 hour format

Snooze function

Thermometer measurement range: 0°C (32°F) ~ 50°C (122°F) (calibration time: 30 seconds)

Hygrometer measurement range: 20% ~ 95% RH. Separate display of indoor use

Battery: 2 x 1.5V "AA" size (not included)
Important information
Initial operation:

Open the battery compartment on the rear side of the receiver and insert the batteries. Pay attention to observe the
correct polarity. Close the battery compartment.

When you insert the batteries, all the icons on the LCD display will briefly light up for 3 seconds, and you will hear a
beep tone, and detect indoor temperature & humidity.

The clock automatically starts the DCF signal search after 7 minutes. The radio mast icon starts to flash.
Manual time setting:

Press and hold down the "SET" button for 2 seconds, the 24 display starts to flash. Now use "▲" and "▼" buttons to
set the correct 12/24 time format.

Press "SET" to confirm your setting, the time zone starts to flash. Now use "▲" and "▼" buttons to set the time
deviation in hourly steps.

Press "SET" to confirm your setting, the Hour display starts to flash. Now use "▲" and "▼" buttons to set the correct
hour.

Press "SET" to confirm your setting, the Minute display starts to flash. Now use "▲" and "▼" buttons to set the correct
minute.

Press "SET" to confirm your setting, the 2008 display starts to flash. Now use "▲" and "▼" buttons to set the correct
year.

Press "SET" to confirm your setting, the Month 1 displays starts to flash. Now use "▲" and "▼" buttons to set the
correct month.

Press "SET" to confirm your setting, the Date 1 start to flash. Now use" ▲" and "▼" buttons to set a correct date.

Press "SET" to confirm your setting, the language default starts to flash. Now use" ▲" and "▼" buttons to set the
desired language for the weekdays.

Press "SET" to confirm your setting and to end the setting procedures, enter the clock mode.
Notes:

To start manual time setting, DCF radio reception must be disabled. Press and hold the "Wave" button for 2 seconds
and the radio symbol goes off.

After 7 seconds without pressing any button, the clock switches automatically from Set Mode to Normal Time Mode.

There are 7 languages of Weekday: English, Italian, French, Netherlands, Spanish, Danish, and German.
WS 8006 Manual
EN1