Zyxel NWA570N Guide De Démarrage Rapide page 4

The LEDs
Look at the LEDs (lights). When you connect the power, the power ( ) LED blinks and stays
on once the device is ready. The LAN (
corresponding connections are properly made.
If the power ( ), LAN ( ) or WLAN (
connections. If this doesn't help, disconnect the NWA570N from its power
source, wait for a few seconds and turn it back on.
2 Set up Your Wireless Network with WPS
You can use Wi-Fi Protected Setup (WPS) to add wireless devices to your wireless
network. The other wireless devices must also support WPS.
Go to Section
1 Place a WPS-enabled device within range of the NWA570N.
2 Press the WPS button on both devices. It doesn't matter which button is pressed first.
You must press the second button within two minutes of pressing the first one.
Your NWA570N has a WPS button located on its casing, as well as a WPS
button available in the web configurator used to manage the NWA570N. Other
WPS-enabled devices should have at least one similar WPS button.
ENGLISH
3 if you do not want to use WPS to set up your network.
) and WLAN (
) LEDs do not turn on, check your
4
) LEDs turn on if the