Wolff Finnhaus Melina 40-B Instructions De Montage page 69

General:
Dear Customer,
Please read these operating instructions carefully before you connect and use
the sauna stove for the  rst time to prevent causing any damage.
Important safety instructions
• The sauna heater is a subassembly and is therefore
independent, meaning that without a suitable control
system it will not fully meet the requirements of the
applicable standards.
• The sauna heater may only be connected to and
operated by an approved sauna control system with
a thermal cut-out for 140°C, otherwise there will be a
serious risk of  re.
• The sauna heater may only be installed by a quali ed
electrician and in this connection EN 60335-2-53 and
requirements with respect to installation and  re pro-
tection measures applicable at the place of use must
be complied with.
• The sauna heater is for private household use only,
a remote control is not permitted and covered ins-
tallation is not permitted. Use only approved control
systems with a thermal cut-out (140°C) in accordance
with EN 60335-2-53.
• For the use of the sauna heater, an approved control
system in accordance with EN 60335-2-53 must be
used. The control system must meet the following
requirements as a minimum:
• The control system must limit the temperature of the
sauna cabin to 135°C. A thermal cut-out which meets
these requirements must be integrated in the sauna
control system which is used, otherwise there will be a
serious risk of  re.
• This control system must have an integrated timer
which limits the operating period to a maximum of 6
Karibu_Anl._ Bio-Saunaofen_37.468.30.indd 9
11
hours, with automatic restart not permitted.
For sauna heaters with an integrated additional vapori-
zer, only an approved sauna control system in accor-
dance with EN 60335-2-53 which also has a humidity
controller is allowed to be used.
• Sauna heater for private household use, remote con-
trol not permitted, covered installation not permitted,
use only suitable control units with thermal cut-outs
in accordance with the information provided by the
manufacturer.
• The installation and electrical connection of the sauna
equipment and other
electrical equipment may only be carried out by a
licensed electrician. (except P & P)
• Refer to the safety actions required by VDE 0100 § 49
DA/6 and VDE 0100 Part 703/11.82 §4. Even if you
comply with the required safety actions it is not
possible to rule out the possibility of all accident risks.
• Follow the safety instructions to the letter to ensure
that you can operate your equipment safely.
• The sauna stove must be operated with a suitable
external control unit.
• The bio sauna stove requires a sauna controller with
a humidity module or a separate additional humidity
controller to activate the evaporator. Instructions
for installing and operating these units are provided in
the manual supplied with the respective controller.
• Only one sauna stove with the appropriate heating
capacity may be installed in the sauna cabin.
(See table)
Connection rating
4,5 kW
9,0 kW
• The equipment does not have approval for use in
commercial saunas and apartment blocks.
• Caution – danger of burns. The case on the sauna
stove and the stones get very hot.
• If it is not installed correctly the unit may cause a  re.
Read the complete assembly instructions with due
care. Pay particular attention to the dimensions and
instructions.
• Only use sauna stones approved for use in saunas.
Insert sauna stones loosely; if the stones are inserted
too tightly there is a danger of overheating.
12.08.21 Technische Änderungen, Druckfehler und Irrtümer vorbehalten
GB
cabine size
< 7 m
3
6 - 14 m 3
9
13.05.20 16:57